We are happy to supply an obligation free quotation for your  rubber track, rubber pad, hybrid steel track or puncture-less tyre requirements.

Please refer to our track size identification information requirements to ensure that you provide us with the correct measurements of your required machinery track.

We carry, or can obtain, hundreds of sizes of tracks and pads to suit almost all excavators and tracked vehicles. If you provide us with the details listed below we can provide a written quotation (including freight) covering your requirements.

If we don't have what you need we will let you know and try to lead you to someone that might.

Rubber Tracks:
If you have the size of the tracks already please quote that in the comments. You can usually find the size of tracks stamped on the inside of the track as shown below:

Rubber Pads:
If you are after a quote for rubber pads, you may still use the submit form below. Include the pad width (track width), the number of pads required (links) and whether bolt-on or clamp-on (pitch), and if they are offset or standard hole configuration in the comments. We may need to get further information from you so please fill out the form fully. There is  a Rubber pad measurement guide sheet available here. Download it to help you provide all the information needed to correctly size and fit your pads.

Hybrid Steel Tracks:
If you are after a quote for Hybrid Steel Tracks you may also use the same submit form. 
Please make sure that you specify the track is to be HYBRID STEEL. Otherwise we will assume you are referring to a Rubber Track.

Should you have any questions regarding your track requirements, please contact us here

Rubber Pads

Contact us with information about our rubber pads and we will provide an obligation free quotation.

Track Size Identification. To correctly quote on your track requirements, we need to know the dimensions of your track. The following will assist you in obtaining these dimensions.  Click here to download a PDF version of this Track Size Identification Sheet, that you can print and take with you to your machine. Tracks are specified using the following minimum formula:- TRACK WIDTH x PITCH LENGTH x NUMBER OF LINKS (e.g.: 230 x 72 x 43 )
TRACK WIDTH: Measure the width (in mm) across the track.
PITCH LENGTH: Measure the distance (in mm) between the centre of one link to the centre of the next link.
(Please Note: On damaged or worn tracks it may be better to measure 10 pitch lengths and divide the total by 10 to get an accurate measure of 1 pitch length. E.g. 550 / 10 = 55 mm pitch length)
NUMBER of LINKS: Count the individual number of links on the entire track.
MACHINE INFORMATION:	The MAKE of your machine ________________________ The MODEL of your machine _______________________
EXTRA INFORMATION:	Occasionally we may require more information such as the profile of the roller, etc. In such cases, we will inform you and specify the information required. Generally, more than 80% of tracks can be identified from the information above.

Is You Machine not listed on the left?

No problem - Get in touch with us and we'll get you the information you need.